3) behind the special adhesive applicator configured in composite foam cement board, binder compacted thickness of about 3, in order to ensure a strong bond, preferably full-stick method, but also can strip and stick method Article point method. 4) stick method: trowel teeth mouth special binder will wipe horizontally uniform foam cement board, strip width 10, xps extrusion board, thickness 10, from 50.5 in) of the point of law: with a trowel in the middle of each plate and wipe surrounding special binder, and then in the area of ??foam cement board partition wipe diameter of 50, xps extrusion board specification, thickness of ash cake 10. EPS Insulation system has the following advantages: 1), has been operating into the system, the technology is mature. Because it has been used for nearly three decades in Europe and the United States, in the United States has built building up to 44 layers. Therefore, this technology has formed a system, xps extrusion board report, the adhesive layer, insulating layer and the facing layer supporting the use of more mature technical documents. 2), good insulation effect. Insulation system, which products do not dare call themselves the product both permeability, good thermal conductivity, good waterproof performance, not absorbent, good for a full accounting. Because these indicators are contradictory, but also pay attention to ventilation breathable construction process after wet water permeability and the system after completion. xps board, many of use are embossed slotted most beneficial use, xps extrusion board formula, the surface treatment, large domestic manufacturers have been realized, some small manufacturers still use a smooth surface xps board is manufacturing methods.